Due to the double-sided coverage of the vacuum panel with extruded polystyrene foam sheets, Vacupor ® XPS  is especially suitable for the plane laying on ceilings and walls.

The fixing of the insulation is much easier, due to the possibility of bonding with commercially available polystyrene adhesives.

Vacupor® XPS is available in two versions:

• Vacupor XPS® 3/3 with 3 mm thick coating on both sides and 
• Vacupor ® PS 10/10 with sides 10 mm coating

Please note:

The building authorities approval No Z-23.11-1662, obtained in June 2009 extends to our products Vacupor ® NT-B2, Vacupor® RP-B2 and Vacupor® PS-B2 only.

Just these products meet the increased demands on fire protection, which are necessary to obtain an buidling authorities approval. This is achieved through a modified version of the barrier film.

In the field of building and construction industry in Germany, all other Vacupor® versions are not approved by the building authorities.These Vacupor ® versions may be applied in areas where a Vacuum Insulation Panel is treated as an unregulated construction product, if an admission on a single case exists or will be obtained.

The thermal conductivity values declared for these Vacupor ® versions FP just describe the value of the Vacuum Insulation Panel under the mentioned conditions, measured in the center of the panel.The measured value does explicitly not correspond with the rated value, determined by the DIBt and may not be used in Germany for the implementation of thermal calculations for buildings.